[Openswan Users] [openswan] cannot route -- route already in
ozai Tien
ozai.tien at gmail.com
Sat Oct 18 14:53:54 EDT 2014
Dear Sirs,
I want to establish 2 ipsec channels between these two as follows.
test1(openswan 162.18.22.80)-----------test2(openswan 162.18.22.81)
test1(openswan 162.18.22.80)-----------test3(openswan 162.18.22.82)
The connection test1-test2 gets established without any problem.
However, when the connection test1-test3 is setup, it gives following error:
117 "test1-test3" #4: STATE_QUICK_I1: initiate
003 "test1-test3" #4: cannot route -- route already in use for "test1-test2"
032 "test1-test3" #4: STATE_QUICK_I1: internal error
Is it the routing issue?How do I check this question?Please help.
Thank you very much.
Best Regards,
Ozai
# cat ipsec.conf
config setup
nat_traversal=no
oe=off
protostack=netkey
interfaces=%defaultroute
conn test1-test2
left=162.18.22.80
leftsubnet=192.168.2.0/24
rightsubnet=192.168.3.0/24
connaddrfamily=ipv4
right=162.18.22.81
keyexchange=ike
ike=3des-md5;modp1024!
salifetime=480m
phase2=esp
phase2alg=3des-hmac_md5!;modp1024
pfs=yes
ikelifetime=60m
type=tunnel
authby=secret
auto=add
conn test1-test3
left=162.18.22.80
leftsubnet=192.168.2.0/24
rightsubnet=192.168.3.0/24
connaddrfamily=ipv4
right=162.18.22.82
keyexchange=ike
ike=3des-md5;modp1024!
salifetime=480m
phase2=esp
phase2alg=3des-hmac_md5!;modp1024
pfs=yes
ikelifetime=60m
type=tunnel
authby=secret
auto=add
#
# cat ipsec.secrets
162.18.22.80 162.18.22.81 : PSK "123"
162.18.22.80 162.18.22.82 : PSK "123"
#
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.openswan.org/pipermail/users/attachments/20141019/bef78ef7/attachment.html>
More information about the Users
mailing list