[Openswan Users] Interpreting "no connection is known" (FreeSwan 1.97)
openswan at JustinLove.name
Sun Jun 9 13:05:03 UTC 2013
On Fri, Jun 7, 2013 at 2:19 PM, Bob Miller <bob at computerisms.ca> wrote:
> I think Mcaffee has it now. As best I've been able to tell It's 1.97,
The other end of the site-site VPN is the same hardware, but I did a
firmware upgrade at some point. pluto reports Openswan 2.6.20dr2 but I'm
not having any better luck.
> > > so you will need the virtualprivate config. There are lots and lots of
I've tried several versions of virtual_private, such as
But It's not being recognized:
# ipsec auto --status
000 virtual_private (%priv):
000 - allowed 0 subnets:
000 - disallowed 0 subnets:
000 WARNING: Either virtual_private= was not specified, or there was a
000 error in that line. 'left/rightsubnet=%priv' will not work!
-------------- next part --------------
An HTML attachment was scrubbed...
More information about the Users