[Openswan Users] single ip not a subnet for leftsubnet

[Alex Crow]

On 04/04/12 21:54, nemus at grayhatlabs.com wrote:
> I am trying to setup an ipsec tunnel between a third party.
>
> The thirdparty specifies two single ip address not subnet ranges in their
> ipsec configuration interface.
>
> How would I specify a single ip address using openswan for the NETKEYS
> routing?
>
> This is something I cannot budge on.
>
> I tried this but it doesn't seam to work.
> leftsubnet = x.x.x.x1/32
>

If the IP addresses are going to be IPSEC endpoints, you can just leave 
out the "leftsubnet" line.

However I find it suprising that specifying a /32 doesn't work. It's a 
perfectly valid way of writing it.

Alex