[Openswan Users] openswan installation problem
kith_yuchen at yahoo.com
Tue Dec 22 12:32:21 EST 2009
yes, i am sure about it, i tried two times got same result.
that's why i feel so strange.
From: Paul Wouters <paul at xelerance.com>
To: yu chen <kith_yuchen at yahoo.com>
Cc: users at openswan.org
Sent: Tue, December 22, 2009 6:19:26 PM
Subject: Re: [Openswan Users] openswan installation problem
On Tue, 22 Dec 2009, yu chen wrote:
> if with same system and install openswan-2.4.12, see below for ipsec verify:
> Checking your system to see if IPsec got installed and started correctly:
> Version check and ipsec on-path [OK]
> Linux Openswan U2.4.12/K2.6.18-164.6.1.el5 (netkey)
> Checking for IPsec support in kernel [OK]
> NETKEY detected, testing for disabled ICMP send_redirects [OK]
> NETKEY detected, testing for disabled ICMP accept_redirects [OK]
> Checking for RSA private key (/etc/ipsec.secrets) [OK]
> Checking that pluto is running [OK]
> Two or more interfaces found, checking IP forwarding [OK]
> Checking NAT and MASQUERADEing [N/A]
> Checking for 'ip' command [OK]
> Checking for 'iptables' command [OK]
> Opportunistic Encryption Support [DISABLED]
> why openswan-2.6.23 show up :
> Pluto listening for IKE on udp 500 [FAILED]
> Pluto listening for NAT-T on udp 4500 [FAILED]
> Two or more interfaces found, checking IP forwarding [FAILED]
That's odd. Are you sure you were running openswan on both checks?
If openswan was not running it would explain things, also because
openswan might set the forwarding sysctl setting.
-------------- next part --------------
An HTML attachment was scrubbed...
More information about the Users