[Openswan Users] openswan installation problem

[yu chen]

Dear Paul 
thank you very much. now openswan can be install to my computer. 
after making sysctl.conf,  ipsec verify, see below:

Checking your system to see if IPsec got installed and started correctly:
Version check and ipsec on-path                                 [OK]
Linux Openswan U2.6.23/K2.6.18-164.6.1.el5 (netkey)
Checking for IPsec support in kernel                            [OK]
NETKEY detected, testing for disabled ICMP send_redirects       [OK]
NETKEY detected, testing for disabled ICMP accept_redirects     [OK]
Checking for RSA private key (/etc/ipsec.secrets)               [OK]
Checking that pluto is running                                  [OK]
Pluto listening for IKE on udp 500                              [FAILED]
Pluto listening for NAT-T on udp 4500                           [FAILED]
Two or more interfaces found, checking IP forwarding            [FAILED]
Checking NAT and MASQUERADEing                                  [N/A]
Checking for 'ip' command                                       [OK]
Checking for 'iptables' command                                 [OK]
Opportunistic Encryption Support                                [DISABLED]
why got failed ?  

thank you very much 

kind regards
kelsen 




________________________________
From: Paul Wouters <paul at xelerance.com>
To: yu chen <kith_yuchen at yahoo.com>
Cc: users at openswan.org
Sent: Mon, December 21, 2009 7:52:37 PM
Subject: Re: [Openswan Users] openswan installation problem

On Mon, 21 Dec 2009, yu chen wrote:

> Dear Paul
> yes, i made mistake.
> now i can use make programs,but ruuning make install got error, see below:

> /bin/sh: xmlto: command not found

yum install xmlto

Paul



      
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.openswan.org/pipermail/users/attachments/20091221/78bd08c4/attachment.html