[Openswan Users] Is it possible to have a separate IPSec interface for every connection

[PVG Ravi Kumar]

Hi,

 

Is it possible to have a separate ipsec interface for every connection?

 

 

I am using openswan 2.4.13 with KLIPS support

My config setup is like this in ipsec.conf file

      config setup

              interfaces="ipsec0=eth0"

               klipsdebug=all

               plutodebug=all

 

 

When I start the ipsec service, an ipsec0 interface is created

 

I established two connections with two peers from the same interface (eth0).
Traffic is flowing between the peers through the tunnels

 

I want to see the traffic statistics of each connection. Since there is only
ipsec interface is created, it is not possible to verify the traffic stats
of each connection. I can see only cumulative stats of all connections.

 

Is there any way to see the traffic stats of each connection separately?

 

Any help or suggestions would be great 

 

 

Thanks in Advance

Ravi


 

DISCLAIMER: This message is proprietary to D-Link (India) Limited and is
intended solely for the use of the individual to whom it is addressed. It
may contain privileged or confidential information and should not be
circulated or used for any purpose other than for what it is intended. If
you have received this message in error, please notify the originator
immediately. If you are not the intended recipient, you are notified that
you are strictly prohibited from using, copying, altering, or disclosing the
contents of this message. D-Link (India) Limited accepts no responsibility
for loss or damage arising from the use of the information transmitted by
this email including damage from virus.
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.openswan.org/pipermail/users/attachments/20080904/a846b350/attachment.html