[Openswan Users] multiple subnets ?

[Indunil Jayasooriya]

> You can however create a tunnel manually by
>
> ipsec auto --up <name_of_the_tunnel>

Thanks for the above command. I did it. I was able to bring up the
remaining tunnels.
Now, All 4 tunnles are up. But, I still can not ping to 4 subnets in
other side.

Could you pls expalin why?

I did traceroute as well. It went through the Usual ( Default route)
path up to a certain extent. But not to the destinaltion. Those
traffice did Not GO throuh the VPN tunnel. I think If I can route
those traffic via VPN, I will be able to ping it.

That's the current status of the set up. I hope you will be able to
give some instructions to go beyond this point.

Pls NOTE: The other side VPN device is CISCO VPN Concentraotor 3000.

This Side vpn devise is CentOS 5 box with 3 network cards. I have
enabled rounting with below line /etc/sysctl.conf

net.ipv4.ip_forward = 1


Hope to hear from you.



-- 
Thank you
Indunil Jayasooriya