[Openswan Users] MODECFG push attributes; how to set them?

lists at higgers.me.uk lists at higgers.me.uk
Fri Jan 11 05:07:44 EST 2008


Hi All,

I'm using Openswan 2.4.9 to push IPv4 config to a client using  
MODECFG.  I've set plutodebug to all and found the following in the log:

Jan 11 09:34:53 mail pluto[28517]: | ****emit ISAKMP ModeCfg attribute:
Jan 11 09:34:53 mail pluto[28517]: |    ModeCfg attr type:  
INTERNAL_IP4_ADDRESS
Jan 11 09:34:53 mail pluto[28517]: | emitting 4 raw bytes of IP4_addr  
into ISAKMP ModeCfg attribute
Jan 11 09:34:53 mail pluto[28517]: | IP4_addr  c0 a8 06 fc
Jan 11 09:34:53 mail pluto[28517]: | emitting length of ISAKMP ModeCfg  
attribute: 4
Jan 11 09:34:53 mail pluto[28517]: | emitting length of ISAKMP Mode  
Attribute: 16

This ties in with the config in my ipsec.conf.  The IP sent to the  
client is 192.168.6.252.  However, the client (a nokia N80 mobile  
phone) then outputs the error "no server found", I assume this is  
because no INTERNAL_IP4_DNS value is being pushed to the client.  How  
can configure Openswan to push DNS, gateway and subnet mask to the  
client?  I'm struggling to find any documentation about mode config  
configuration.

Kind regards,

Steve.




More information about the Users mailing list