[Openswan Users] [Openswan dev] book example yields - No route to host...not authenticated using

[Bruce S. Skinner]

Paul Wouters <paul at xelerance.com> writes:

> On Sun, 26 Nov 2006, Bruce S. Skinner wrote:
>
>> >> >> Is this an authentication issue or a routing issue?
>> >> >
>> >> > A router in the midde, 172.31.1.200, cannot reach 10.1.1.11.
>
>> > that should not happen. Are you sure you are not firewalling udp port 500?
>>
>> iptables -L shows nothing on all three machines left, right and router.
>
>> Nov 26 19:37:33 gw pluto[4867]: "sample" #1: ERROR: asynchronous network error report on eth0 (sport=500) for message to 172.31.1.200 port 500, complainant 10.1.1.11: No route to host [errno 113, origin ICMP type 3 code 1 (not authenticated)]
>
>> I know.  These three machines are vmware virtual machines, and are
>> just templates for real hardware once I see this flying...
>
> then I guess it has to do with the vmware bridging magic.

Hmmm... Racoon ran fine on this setup.  I'll round up a couple of bits
of real intel hardware tomorrow and try it on them.

regards :-)
BruceS

>
> Paul
> -- 
> Building and integrating Virtual Private Networks with Openswan:
> http://www.amazon.com/gp/product/1904811256/104-3099591-2946327?n=283155

-- 

Norstead Farm - Bruce & Carole Skinner
RR#1 Waterville NS Canada B0P 1V0
 Tel: 902-538-1765
Cell: 902-670-6456
 Fax: 902-538-1794
<mailto:bruce.skinner at norsteadfarm.ca>