[Openswan Users] net 2 net connection

William Man williamman at visualrock.co.uk
Tue Sep 20 15:04:56 CEST 2005


Sorry, what I mean is the 4 tunnels are all up on both ends.  However, there
appears to be some kind of software error being generated.
When Site1 tries to connect it fails, but when Site2 trieds it works.  It is
baffling

W


----- Original Message ----- 
From: "Paul Wouters" <paul at xelerance.com>
To: "William Man" <williamman at visualrock.co.uk>
Cc: <users at openswan.org>
Sent: Tuesday, September 20, 2005 1:52 PM
Subject: Re: [Openswan Users] net 2 net connection


> On Tue, 20 Sep 2005, William Man wrote:
>
> > I've finally set up all the tunnels. Decided not to tinker with routing,
as
> > it seemed complicated as hell.  I now have the following tunnels:
> > net-to-net
> > site1-to-net
> > site2-to-net
> > site1-to-site2
> >
> > However, I am still getting the problem that only site2 can connect to
> > site1.  When I try from site1 to connect to site2 i get the messages
below.
>
> you will need on site1:
>
> site1-site2
> site1-net2
> net1-site2
> net1-net2
>
> On site2 you need the same four tunnels.
>
> Paul
> ________________________________________________________________
> This email has been scanned by ClamAV, and should be virus free.
>

________________________________________________________________
This email has been scanned by ClamAV, and should be virus free.


More information about the Users mailing list