[Openswan Users] Openswan+Ipv6 probem....again....

zze-DURBEC Mathieu FTRD/DTL/ISS mathieu.durbec at rd.francetelecom.com
Thu May 13 17:41:10 CEST 2004


Hi,
I've been trying for days to set up OpenSWAN with IPv6 support...
So, I'am using the 2.1.1 version patched with Mikael Magnusson'patch..
It doesn't seem to work with ipv6  :,-(
Here's my config

Ifconfig :

eth0    Lien encap:Ethernet  HWaddr 08:00:46:A8:E2:3B  
          adr inet6: 2001:688:1f8b:a000::1/0 Scope:Global
          adr inet6: fe80::a00:46ff:fea8:e23b/64 Scope:Lien
          UP BROADCAST RUNNING MULTICAST  MTU:1500  Metric:1
          RX packets:3530 errors:0 dropped:0 overruns:0 frame:0
          TX packets:14 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 lg file transmission:100 
          RX bytes:211800 (206.8 Kb)  TX bytes:964 (964.0 b)
          Interruption:11 Adresse de base:0x2000 

Route :

Table de routage IPv6 du noyau
Destination                                 Prochain Hop
Indic Metric Ref    Utilis. Iface
::1/128                                     ::
U     0      11       1 lo      
2001:688:1f8b:a000::1/128                   ::
U     0      3        0 lo      
fe80::209:5bff:fe1e:791/128                 ::
U     0      0        0 lo      
fe80::a00:46ff:fea8:e23b/128                ::
U     0      0        0 lo      
fe80::/64                                   ::
UA    256    0        0 eth0    
fe80::/64                                   ::
UA    256    0        0 eth1    
ff00::/8                                    ::
UA    256    0        0 eth0    
ff00::/8                                    ::
UA    256    0        0 eth1    
::/0                                        ::
UDA   256    0        0 eth0    
::/0                                        ::
UDA   256    0        0 eth1    

And ipsec.conf

# /etc/ipsec.conf - FreeS/WAN IPsec configuration file
# RCSID $Id: ipsec.conf.in,v 1.11 2003/06/13 23:28:41 sam Exp $

# This file:  /usr/local/share/doc/freeswan/ipsec.conf-sample
#
# Manual:     ipsec.conf.5
#

version	2.0	# conforms to second version of ipsec.conf specification

# basic configuration
config setup
	forwardcontrol=yes
	interfaces="ipsec0=eth0"
	uniqueids=yes
	# Debug-logging controls:  "none" for (almost) none, "all" for
lots.
	klipsdebug=all
	plutodebug=all
	syslog=syslog.debug


Does someone manage to make it work ???

Thanks 

Matt
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.openswan.org/pipermail/users/attachments/20040513/a38d0774/attachment.htm


More information about the Users mailing list