[Openswan Users] server fails to add route to roadwarrior

[Robert W. Burgholzer]

That did the trick! I located my default route, and put it in as a 
"nexthop" params and all was hunky-dory. Thanks a ton!

r.b.


At 10:55 AM 3/26/2004 -0600, you wrote:
>On Fri, 26 Mar 2004, Robert W. Burgholzer wrote:
> > Server Routing Table:
> > Kernel IP routing table
> > Destination     Gateway         Genmask         Flags Metric Ref    Use 
> Iface
> > 192.168.1.0     *               255.255.255.0   U     0      0        0 
> eth0
> > 12.5.16.0       *               255.255.252.0   U     0      0        0 
> eth1
> > 12.5.16.0       *               255.255.252.0   U     0      0        0 
> ipsec0
> > 127.0.0.0       *               255.0.0.0       U     0      0        0 lo
> > default         *               0.0.0.0         U     0      0        0 
> eth1
>
>I believe this is your problem - Openswan expects there to be a default
>gateway set, not just a default interfaces. Is there any way you can find
>out what the proper next hop is? 12.5.16.1 or .254 would be my guesses.
>
>------------------------------------------------------------------------
>| nate carlson | natecars at natecarlson.com | http://www.natecarlson.com |
>|       depriving some poor village of its idiot since 1981            |
>------------------------------------------------------------------------
>_______________________________________________
>Users mailing list
>Users at lists.openswan.org
>http://lists.openswan.org/mailman/listinfo/users

Robert Burgholzer
Environmental Engineer
MapTech Inc.
http://www.maptech-inc.com/