[Openswan dev] Error building klips-ipv6 (missing include?)

[Harald Jenny]

On Wed, Oct 13, 2010 at 08:26:39AM +1000, David McCullough wrote:
> 
> Jivin Paul Wouters lays it down ...
> > On Tue, 12 Oct 2010, David McCullough wrote:
> > 
> > >>> Is 2a02:bd0:abcd:3::20/64 an address that's configured as a real IP address
> > >>> on a real physical interface? If so, it should always show up in the listen
> > >>> list. Can you give me a plutodebug=all of "ipsec setup start"?
> > >>
> > >> Shouldn't this be done by tncfg? Maybe there lies the source of the problem?
> > >
> > > Yes,  but if "ipsec setup start" runs before the interface has an IPv6
> > > address,  then it won't be picked up.
> > 
> > tncfg just binds virtual interfaces to physical ones. It does nothing with IP
> > addresses.
> 
> Yes,  but _startklips,  which is run by "ipsec setup start" configured the
> IP addresses onto the ipsecX devices.  I know because I had to add code
> in there for IPv6 ;-)

Seems like IPv6 for KLIPS/MAST really goes on...

> 
> The master branch uses ifconfig while the klips-ipv6 branch uses iproute2.
> I'd actually like to bring these user space changes (mostly minor) across to
> mainline at some point ;-)

Very good idea, indeed.

> 
> Cheers,
> Davidm

Kind regards
Harald

> 
> -- 
> David McCullough,      david_mccullough at mcafee.com,  Ph:+61 734352815
> McAfee - SnapGear      http://www.mcafee.com         http://www.uCdot.org