<!DOCTYPE html PUBLIC "-//W3C//DTD HTML 4.01 Transitional//EN">
<html>
<head>
<meta content="text/html;charset=iso-8859-1" http-equiv="Content-Type">
</head>
<body bgcolor="#ffffff" text="#000000">
This is a cool way to do it. I should really get more into subnet
masks 'cause I know little about it.<br>
<br>
Thanks.<br>
<br>
Bob Miller wrote:
<blockquote cite="mid:1271714074.6793.40.camel@laplaplian" type="cite">
<pre wrap="">Mike,
depending on exactly the range, you can make a subnet that will work for
only the range you are looking for. eg, to have two addresses;
192.168.1.21 and and 192.168.1.22, you can use 192.168.1.20/30, which
would give you .20 as your network address, .23 would be the broadcast,
and .21 and .22 would be your range.
Hope that helps...
On Mon, 2010-04-19 at 13:23 -0400, Mike A. Leonetti wrote:
</pre>
<blockquote type="cite">
<pre wrap="">Is there a way to set the subnet to an IP range instead of an entire
subnet? I need to satisfy this message when I try and bring up a VPN to
a Sonicwall.
peer client ID payload in Quick I1, ID_IPV4_ADDR_RANGE 192.168.1.21 -
192.168.1.22 unacceptable: not a valid subnet
_______________________________________________
<a class="moz-txt-link-abbreviated" href="mailto:Users@openswan.org">Users@openswan.org</a>
<a class="moz-txt-link-freetext" href="http://lists.openswan.org/mailman/listinfo/users">http://lists.openswan.org/mailman/listinfo/users</a>
Building and Integrating Virtual Private Networks with Openswan:
<a class="moz-txt-link-freetext" href="http://www.amazon.com/gp/product/1904811256/104-3099591-2946327?n=283155">http://www.amazon.com/gp/product/1904811256/104-3099591-2946327?n=283155</a>
</pre>
</blockquote>
<pre wrap=""><!---->Bob Miller
334-7117/633-3760
<a class="moz-txt-link-freetext" href="http://computerisms.ca">http://computerisms.ca</a>
<a class="moz-txt-link-abbreviated" href="mailto:bob@computerisms.ca">bob@computerisms.ca</a>
Network, Internet, Server,
and Open Source Solutions
</pre>
</blockquote>
</body>
</html>